In-ceiling Housing Installation Manual SHD-2510FPW
TABLE OF CONTENTS Overview...................................................................................................................................... 3 What’s Included........................................................................................................................... 3 Installation Instructions................................................................................................................ 4 Installation........................................................
OVERVIEW This In-CEILING HOUSING is a mounting ADAPTOR that is designed to mount the multi-directional camera in built-in style on a double-layer ceiling. ` Applicable model : PNM-9084QZ / PNM-8082VT ※※ Supported models are subject to change.
INSTALLATION INSTRUCTIONS 1. Select an installation position or place that can endure more than 4 times of the total weight of the installation structure. 2. At least 250mm or more of spare height is required above the CEILING BOARD. 3. CEILING BOARD’s thickness should be less than 50mm. 4. Be sure to secure the SAFETY WIRE to avoid a product fall. 5. If you want to attach the camera to the ADAPTOR, use the only provided SCREWS. 6. CEILING BOARD must be able to sustain the weight of at least 10 kg.
2. Attach the mount template to a surface you want and drill holes. 3. Remove the CAP and NUT that fit to the size of the HOLE you are going to use.
4. Follow the Disassembling section in the camera manual to remove the dome cover and mounting plate. 5. Use the screws (camera components) to join the mounting plate to the housing.
6. Fix the ANCHOR BOLT onto the concrete CEILING, and secure the SAFETY WIRE to the ANCHOR BOLT as below: ➊ Tighten the NUT (“N1”) on the ANCHOR BOLT. ➋ Insert the provided SAFETY BRACKET into the ANCHOR BOLT. ➌ Tighten two NUTs (“N2”,”N3”) onto the ANCHOR BOLT. ➍ Hook and fix one end of the SAFETY WIRE onto the SAFETY BRACKET.
7. In the case that the pipe is to be connected to the External Cable hole, the pipe must be inserted within the depth of 15mm or less. Less than 15mm 8. To connect to the camera, insert the external cable through the Cable hole on the housing to the inside of the housing as shown in the figure. to the installation manual of the camera that you want to install, and prepare necessary MM `` Refer cables for camera connection.
. Push the HOUSING inside the CEILING through the CEILING hole, and tighten the SCREWs (x2) clockwise to fix the HOUSING on the CEILING. (The BRACKET will be positioned from to as shown.) a power tool for installation could cause product damage. MM `` Using If you are going to use a power tool, the torque must be 30 Nm or less. `` Ensure that the HOUSING is firmly secured to the CEILING BOARD. BRACKET SAFETY WIRE BRACKET HOUSING BRACKET BRACKET SCREW Turn clockwise 10.
11. A lign and attach the COVER to the HOUSING following the arrow, and tighten the four SCREWS on the COVER to fix it to the HOUSING.
Head Office 6, Pangyo-ro 319 beon-gil, Bundang-gu, Seongnam-si, Gyeonggi-do, 463-400 Rep. of KOREA Tel : +82.70.7147.8753 Fax : +82.31.8018.3740 www.hanwha-security.com Hanwha Techwin America 500 Frank W. Burr Blvd. Suite 43 Teaneck, NJ 07666 Toll Free +1.877.213.1222 Direct +1.201.325.6920 Fax +1.201.373.0124 www.hanwha-security.com Hanwha Techwin Europe Heriot House, Heriot Road, Chertsey, Surrey, KT16 9DT, United Kingdom Tel +44.1372.235663 Fax +44.1932.57.8101 www.hanwha-security.