User Manual
Table Of Contents
- Samsung Galaxy S20 5G|S20 5G UW|S20+ 5G|S20 Ultra 5G User manual
- Contents
- Getting started
- Galaxy S20 5G
- Galaxy S20 5G UW
- Galaxy S20+ 5G
- Galaxy S20 Ultra 5G
- Set up your device
- Start using your device
- Turn on your device
- Use the Setup Wizard
- Transfer data from an old device
- Lock or unlock your device
- Side key settings
- Accounts
- Set up voicemail
- Navigation
- Navigation bar
- Customize your home screen
- Samsung Daily
- Bixby
- Digital wellbeing and parental controls
- Always On Display
- Biometric security
- Mobile continuity
- Multi window
- Edge screen
- Enter text
- Emergency mode
- Camera and Gallery
- Apps
- Settings
- Access Settings
- Connections
- Sounds and vibration
- Notifications
- Display
- Screen brightness
- Motion smoothness
- Blue light filter
- Dark mode
- Screen mode
- Font size and style
- Screen zoom
- Screen resolution
- Full screen apps
- Screen timeout
- Accidental touch protection
- Touch sensitivity
- Show charging information
- Screen saver
- Reduce animations
- Lift to wake
- Double tap to wake
- Smart stay
- One-handed mode
- Device maintenance
- Lock screen and security
- Accounts
- Accessibility
- Other settings
- Learn more
- Legal information
Tools
The Tools panel provides handy instruments for quick access.
1. From any screen, drag the Edge handle to the center of the screen. Swipe until
the Tools panel is displayed.
2. Tap a tool to use:
• Compass: Identify compass directions.
– Tap Calibrate to calibrate the compass.
• Tally counter:Use the plus and minus icons to add or subtract while counting.
– Tap Vibration to enable or disable vibrations with each addition or
subtraction.
– Tap Target to set a total target number between 1 and 9999.
–
Tap Reset to reset the counter.
•
Flashlight: Tap Flashlight to turn the flashlight on and off. Use the plus
and minus icons to increase or decrease the brightness of the light.
– Tap SOS to make the flashlight signal the phrase “SOS” in Morse code.
• Surface level: Use the device to determine if a surface is level by placing the
device on the surface. The surface is level when the x and y values are close
to or equal to zero degrees.
– Tap Calibrate to calibrate the level.
• Ruler: Use the edge of the device as a ruler to measure a straight line in
either inches or centimeters. Tap the unit name to change the units.
Configure Edge panels
You can customize the Edge panels.
1.
From the Edge screen, tap Settings.
2. Tap to enable the feature. The following options are available:
•
Checkbox: Enable or disable each panel.
• Edit (if available): Configure individual panels.
•
Search: Find panels that are either installed or available to install.
43
Getting started