User Manual

3
The RF exposure limit set by the FCC for wireless devices
employs a unit of measurement known as the Specific
Absorption Rate (SAR). The SAR is a measure of the rate of
absorption of RF energy by the human body expressed in units
of watts per kilogram (W/kg). The FCC requires wireless
devices to comply with a safety limit of 1.6 watts per kilogram
(1.6 W/kg).
The FCC SAR limit incorporates a substantial margin of safety
to give additional protection to the public and to account for
any variations in measurements.
SAR tests are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well
below the maximum reported value. This is because the
device is designed to operate at multiple power levels so as to
use only the power required to reach the network. In general,
the closer you are to a wireless base station antenna, the
lower the power output of the device.
Before a new model device is available for sale to the public, it
must be tested and certified to the FCC that it does not exceed
the SAR limit established by the FCC. Tests for each model
phone are performed in positions and locations (e.g. at the ear
and worn on the body) as required by the FCC.
For body-worn operation, this device has been tested and
meets FCC RF exposure guidelines when used with an
accessory that contains no metal and that positions the mobile
device a minimum of 1.5 cm from the body.
Use of other accessories may not ensure compliance with FCC
RF exposure guidelines. The FCC has granted an Equipment
Authorization for this mobile device with all reported SAR
levels evaluated as in compliance with the FCC RF exposure
guidelines.