Samsung-V100T LTE Mobile HotSpot PRO User Guide
Table Of Contents
- Samsung LTE Mobile HotSpot Pro
- Section 1: Getting Started
- Section 2: Understanding Your Device
- Section 3: Connecting Your Device
- System Requirements
- Before You Begin a Connection
- Initial Connection to Your Device
- Accessing Your HotSpot via a Browser
- Configuring Your HotSpot
- Preparing your HotSpot for File Access
- Installing the USB drivers for various OS types
- Connecting your Computer to the HotSpot via USB
- Factory Reset via the Web Portal
- Using the Battery Pack Feature
- Section 4: Home Page
- Section 5: Network Page
- Section 6: Securing Your Device
- Section 7: Configuring Your Device
- Section 8: Messaging on Your Device
- Section 9: Troubleshooting
- Section 10: Health and Safety Information
- Exposure to Radio Frequency (RF) Signals
- Specific Absorption Rate (SAR) Certification Information
- FCC Part 15 Information to User
- Radio Frequency (RF) Energy
- Knowing Radio Frequency Safety
- FCC Radio Frequency Emission
- Samsung Mobile Products and Recycling
- UL Certified Travel Charger
- Display / Touch-Screen
- Battery Use and Safety
- Care and Maintenance
- Operating Environment
- Restricting Children's Access to Your Wireless Mobile Device
- FCC Notice and Cautions
- Other Important Safety Information
- Section 11: Warranty Information
- Index
Charging Head
USB Cable
Charging the Battery
Your device is powered by a rechargeable Li-ion battery. A
wall charger, which is used for charging the battery, is
included with your device. Use only approved batteries and
chargers. Ask your local Samsung dealer for further details.
Before using your device for the first time, you must fully
charge the battery.
Note:
Verify that the battery is installed prior to connecting the
wall charger. If both the wall charger is connected and
the battery is not installed, the device can power cycle
continuously and prevent proper operation. Failure to
unplug the wall charger before you remove the battery,
can cause the device to become damaged.
Important!
It is recommended you fully charge the battery
before using your device for the first time.
1. Connect the USB cable to the charging head.
2. Locate the Charging port.
3. Insert the USB cable into the device’s Charger/
Accessory jack.
4. Plug the charging head into a standard AC power
outlet. The device turns on and indicates both its
charge state and percent of charge.
8