Samsung-V100T LTE Mobile HotSpot PRO User Guide
Table Of Contents
- Samsung LTE Mobile HotSpot Pro
- Section 1: Getting Started
- Section 2: Understanding Your Device
- Section 3: Connecting Your Device
- System Requirements
- Before You Begin a Connection
- Initial Connection to Your Device
- Accessing Your HotSpot via a Browser
- Configuring Your HotSpot
- Preparing your HotSpot for File Access
- Installing the USB drivers for various OS types
- Connecting your Computer to the HotSpot via USB
- Factory Reset via the Web Portal
- Using the Battery Pack Feature
- Section 4: Home Page
- Section 5: Network Page
- Section 6: Securing Your Device
- Section 7: Configuring Your Device
- Section 8: Messaging on Your Device
- Section 9: Troubleshooting
- Section 10: Health and Safety Information
- Exposure to Radio Frequency (RF) Signals
- Specific Absorption Rate (SAR) Certification Information
- FCC Part 15 Information to User
- Radio Frequency (RF) Energy
- Knowing Radio Frequency Safety
- FCC Radio Frequency Emission
- Samsung Mobile Products and Recycling
- UL Certified Travel Charger
- Display / Touch-Screen
- Battery Use and Safety
- Care and Maintenance
- Operating Environment
- Restricting Children's Access to Your Wireless Mobile Device
- FCC Notice and Cautions
- Other Important Safety Information
- Section 11: Warranty Information
- Index
mini USB Cable
Installation of the RNDIS windows USB Driver
1.
With the HotSpot not yet connected, locate the
WIndows
®
version of the Samsung USB Driver for
Mobile Phones (RNDIS) found on product page @
www.samsung.com
.
2. Run the installation packag
e for the file named:
SAMSUNG_USB_Driver_for_Mobile_Phones_v1.5.25.o.
exe
.
3. Follow the on-screen instructions.
Important!
It is important that you select the disk running the
Windows operating system. Choosing a different
disk can result in an installation failure.
Important!
If an installation failure occurs, unplug the device,
reboot the machine, and rerun the installation
procedures above.
4. Connect the HotSpot to the computer using the USB
connector (
page 21).
Connecting your Computer to the
HotSpot via USB
This method can be used to provide USB Tethering to your
computer.
1. Using your fingertip (1), slide the mini USB connector
out from its current location (2).
Connecting Your Device 21