Installation Guide (Installation manual) (ver.1.0)

12

13

 

A1 

PROPER DAMPER OPERATION

The exhaust Adaptor and Damper are
shipped assembled and attached to
the filler-upper.
1. Slide the exhaust adaptor as shown in the
diagram above.
2. Make sure the tape securing the damper is
removed and damper pivots easily before you
mount the microwave.
: You will need to make adjustments to
assure proper alignment with your house exhaust
duct after the microwave is installed.
A2 
After you have installed the microwave, you will
need to open the top cabinet and adjust the exhaust
adaptor so that you can connect it to the house
duct.



Blower Plate

Microwave
Damper
NOTE: You must attach the house duct to the
exhaust adaptor after installation is complete.
House Duct

 

B1 

2. Lift up the
blower plate.
1. Remove and save the screws
that hold the blower plate to the
microwave.

Microwave
NOTE: The exhaust adaptor with the damper is not
needed for recirculating models. You may want to
save them for possible future use.
3. Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4. Roll the blower unit 90 ° so that the fan blade
openings are facing toward the front of the
microwave.
SMH1927_XAA_DE68-04108A-01_EN_120725.indd 12 2012-07-25 �� 7:54:33