Installation Guide (Installation manual) (ver.1.0)
12
13
NOTE: You must attach the house duct to the
exhaust adaptor after installation is complete.
B1
NOTE: The exhaust adaptor with the damper is not
needed for recirculating models. You may want to
save them for possible future use.
3. Remove the screw that holds the blower motor
and carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
blower mortor screw
: To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4. Roll the blower unit 90 ° so that the fan blade
openings are facing toward the front of the
microwave.
Microwave
Before Roll
After Roll
Microwave
5. Place the blower unit back into the opening.
: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
6. Secure the blower unit to the microwave with the
screw.
B2
1. Remove the screws on the top of the grill using a
#1 Phillips screwdriver.
2. Open the door.
3. Remove the grill.
• Pushthegrillleft,andthenpullthegrillstraight
o.
4. Install the charocal filter. When properly installed,
the wire mesh of the filter should be visible from
the front.
5. Reinstall the grille and the screws.
6. Close the door.
SMH1927_XAA_DE68-04108A-01_EN_120725.indd 13 2012-07-25 �� 7:54:34