Installation Guide (Installation manual) (ver.1.0)
14
15
1. Remove and save the screws that hold the
Blower Plate to the microwave.
2. Lift up the
Blower plate.
Screw
Blower Motor
Blower Plate Screw
3. Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
Openings Facing Forward
End B
End A
To avoid breaking or cracking the blower
blade, do not touch the blade. Hold the outer case
of the blower when you pull it out or put it back in
place.
4. Remove Parts “A” with tin snips or pliers.
5. Rotate the blower unit counterclockwise 180 °.
Before Rotation After Rotation
6. Place the blower unit back into the opening.
End B
End A
pinched.
microwave oven.
7. Close the Blower Plate and attach the exhaust
adaptor to the rear of the oven by sliding it into
the guides at the back top center of the oven.
Push in securely until it is in the lower locking
tabs. Take care to ensure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
Adaptor
Guide
Microwave
Guide
From Blower motor screw
A. Prepare Rear Wall (horizontal duct only)
B. Attach Mounting Plate to Wall
. Prepare Top Cabinet
D. Mount the Microwave Oven
E. Connecting Ductwork (vertical duct only)
You need to cut an opening in the rear wall for
outside exhaust.
• Readtheinstructionsforoutsidebackexhaust
on the REAR WALL TEMPLATE.
• TapetheREARWALLTEMPLATEtotherear
wall.
• Cuttheopening,followingtheinstructionson
the REAR WALL TEMPLATE.
Do not cut an opening in the rear wall if
you are installing the microwave with vertical duct or
non-vented ductless ventilation.
SMH1927_XAA_DE68-04108A-01_EN_120725.indd 14 2012-07-25 �� 7:54:35