Manual

connect na to TV
VIEWING ON A TV SCREEN
1. Turn on your TV and set the TV's input selector(source) to the input
the camcorder is connected to. -page 93
• The TV jacks are connected with the right cables?
• Input source list is correctly set to view the playback from the
camcorder?
2. Select the playback mode on your camcorder and start to playback
videos.
• Use the same methods for the operation modes including the
playback.
• Adjust the volume at the moderale level. If the volume is too high, the video informalion may include
the noise.
• Ifthe "rv Display" is set "Off," TV screen does not include the OSD (On Screen Display) menus.
", page 90
• This camcorder does not support the audio output signal when the camcorder is connected
with TV in the video or photo record mode. The audio output signal is supported as long as the
camcorder is connected in the video playback mode. This is not an error.
il I I P.TI [=Ill _'_vll [=] If=] I [l III [i El] I I d[l_ IJl:.l I [l il |TI_"[I+ L=_=] I l P.I I [el
Icon O Subject
16:9
4:3
Refer to page 49 for the "16:9 Wide" setting,