Operation Manual

46_ network connection and setup

network connection and setup

3. In the <Address> pane, provide the

necessary information.

• MAC (Ethernet) Address : The MAC

address imprinted on the camera

label is automatically displayed and

requires no user setting.

IP related parameters can be set only

when DHCP is not checked.

If not using a Broadband Router

For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network

administrator.

4. In the <Port> pane, provide necessary

information.

• HTTP Port : Used to access the

camera using the Internet browser,

defaulted to 80.

• VNP Port : Used to control the video

signal transfer, defaulted to 4520.

5. Enter the password.

Enter the password of “admin” account, which was used to access the camera.

The default password is “4321”.

The default password can be exposed to a hacking thread so it is recommended to change the

password after installing the product.

Note that the security and other related issues caused by the unchanged password shall be

responsible for the user.

If you want to change the password, refer to “Administrator password change” of the user

setup. (page 120)

6. Click [OK].

Manual network setup will be completed.