Operation Manual

English _15
● OVERVIEW
Item Description

Internal Cover It is a cover to protect the main body.
b
Illumination Sensor Detects incoming light to control the IR LED.
c
Lens Lens for the camera.

IR LED These infrared LED’s are controlled by the illumination sensor.

Alarm Input Port
ALARM IN
Used to connect the alarm input sensor or external day/
night sensor.
GND Common port for alarm output signal.

Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.

Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.

Micro SD Memory
Card Compartment
Compartment for the Micro SD memory card.

The Micro SD Card port may not be supported depending on the regions.

PoE Connector Connects to the network and supplies power through Ethernet cable.