User Manual

· English

Mounting the SmartCam D1

Disassembling

1. Use a screwdriver to remove your existing doorbell.

Disconnect the wires from behind the doorbell

carefully.

Install on the wall

` Check whether or not the camera installation position is suitable for good video

reception.

1. Mark the position of the mounting holes for your

new doorbell.

2. Drill the holes about 1.2 inches deep into the wall.

(Recommended Drill Bit size is 0.2 inches)

` It is recommended to use a drill bit (Ø5) that is suitable

for the wall material.

` Be careful not to get injured while drilling.

3. Unscrew one of the power terminals on the back of your

SmartCam D1, and wrap the existing wiring from your

doorbell around the terminal, and then tighten the screw.

` It doesn't matter which cable you use on which side of the

terminal back.

4. Optional Step for Extending Power Supply (Requires

Power Extension Kit):

4-1

If existing wire is too short, use the Power Cable

Extender and connect the flat circular end of it to

the terminal, then screw the terminal back on.

4-2 Pull the orange levers on the terminal blocks up.

4-3 Insert the existing cable from the wall to one of

the slots and push the orange lever back down.

4-4 Insert the new power cable from the doorbell to the other slot and pull

the lever back down in place.

4-5 Repeat this process for the other side.

5. Mount the SmartCam D1 on the wall.

5-1 Insert the anchors into the holes

completely.

5-2 Tuck the wires attached to the

doorbell back into the wall and

align the two holes on the doorbell

with the holes in the wall.

5-3 Screw the SmartCam D1 tightly

into the wall.

` Make sure to remove the faceplate attached to your SmartCam D1 to access the

mounting holes.

RESET