Operation Manual

`
If the “Error” message does not disappear after following the instructions, format the SD card.
After formatting, if the error message still remains, replace the SD card.
`
If you remove the SD card without changing a button to ‘off’ position in settings or if you connect
a camera to an unstable power source, the SD card may be damaged.
To make recording on the SD memory
1. Check the memory card’s <Free size> and <Total size>.
2. Otherwise, check the stored data and if you find them not important, then click
<Format> to format the SD memory.
`
Some frames may be skipped if the SD memory card operates at the lower speed than recommended.
For more details, refer to “Recommended SD/SDHC/SDXC Memory Card Specifications”. (Page 11)
`
For a SD memory card with a large capacity, the formatting will be slowed down accordingly.
`
The data traffic will increase when the camera is set to higher resolution, higher bit rate, and/or higher
framerate.
If there is too much data traffic, some frame may be skipped although it is stored in a full frame.
`
When a frame skip occurs, images are saved at the rate of min. one image per sec.
3. Specify the storage action.
Record profile : The name of the recorded profile will be displayed.
Normal : Make recording at a certain frame rate.
Event : Set the recording type for a certain event that occurs.
Pre event duration : Specify the time point before the occurrence of the event;
starting from the time point, the images will be transferred. You can specify up to
5 seconds before the occurrence of the event.
Post event duration : Specify the time point after the occurrence of the event; to
the specified time point, the images will be transferred. You can specify up to 120
seconds after the occurrence of the event.
Record file type : It specifies the file format of the recorded images.
If you insert a SD card saved in another saving file type (AVI/STW), you will need
to format it before use.
- STW : It is Samsung’s unique file format.
- AVI : It is the conventional avi format.
Overwrite : If the SD memory is full, this will delete old data and store new data in
replacement.
Auto delete : Data for a certain period is deleted, while other data is not deleted.
This can be set within the range of one day to 180 days.
J
`
If the storage period is expired, data is automatically deleted and new data will be recorded. Once
deleted, it cannot be recovered.
English _109
SETUP SCREEN