Operation Manual

setup screen
96_ setup screen
IR Setup
1. Select <IR>.
2. Select each item and set it properly.
• IR Mode:
- Off : Turns off IR LED.
- On : Turns on IR LED.
When using, the daytime/nighttime
mode of the special is set to B/W.
- Day/Night : Turns on/off IR according to the day & night mode.
When the mode is set, the day & night mode of the special cannot be set.
- Sensor : Changes the IR and day & night mode according to the light flux
detected by the light sensor.
When the mode is set, the daytime/nighttime mode of the special cannot be
set.
- Timed : Sets the IR usage time.
When the mode is set, the day & night mode of the special cannot be set.
• LED On Level : LED is turned on when the light flux is lower than the LED usage
level. 1 ~ 90 can be set.
• LED Off Level : LED is turned off when the light flux is higher than the LED usage
level. 11 ~ 100 can be set.
• LED On Time : Sets the time when IR will remain turned on.
• LED Max. Power : Sets the highest brightness of IR.
• LED Power Control: Controls screen saturation caused by a nearby object.
If set to <Off>, the LED output is not controlled even when the screen is
saturated.
M
`
When you set the IR mode to <On>, the LED comes on and the screen is automatically set to
black-and-white mode. When you set the IR mode to <Off>, the LED goes off and day-and-night
mode is automatically set.
`
If the zoom magnification is changed while the IR dimmer is being used, the IR dimmer is
interfaced to the zoom magnification.
However, the interface of IR dimmer to zoom magnification may slow down at a low temperature.
`
If the ambient temperature is too high, IR LED may be forcefully turned off to protect the product.