User`s manual
33
Chapter 4 Static IP Setting
Manual Network Setting
32
Searching for SNT-1010 (Continued)
Network Connection & Setup
1
<Device Name> : Model name of SNT-1010.
2 <Mode> : Shows the current selection among from <Static>and <Dynamic>.
3 <Mac Address> : The Mac address of the network interface of SNT-1010 that is printed on the rear panel.
4
<IP Address> : The IP address of SNT-1010.(Default setting is '192.168.1.200'.)
5 <UPnP Status> : The SNT-1010 on which the automatic port mapping (port forwarding) is done using UPNP
is marked with <Success>.
6 <URL> : This is an DDNS URL address that can be used to connect from an external Internet.
However, if the DDNS fails to register with your PC, it will be displayed as an IP address of
SNT-1010.
7 [Search ] Button : Searches for SNT-1010 connected to the current network.
8 [Auto Set ] Button : Sets up the SNT-1010 network settings automatically using the <IP Installer>.
9 [Manual Set ] Button : Allows the user to set up the SNT-1010 network settings manually.
10 [Exit ] Button : Exits the IP Installer program.
IP Installer screen layout
123 45 6
10987
Static IP Setting
Manual Network Setting
1
Select an SNT-1010 you want from the SNT-1010 list.
Confirm the MAC Address of the SNT-1010 on its rear panel.
The [Auto Set] and [Manual Set] button are activated.
2
Click the [Manual Set] button.
The Manual Set window appears.
The <IP Address>, <Subnet Mask>, <Gateway> and
<HTTP Port> values of the SNT-1010 are displayed in
their default values.
The password is set to 4321 by factory default.
3
Set up the IP related settings in the <ADDRESS>field.
<MAC Address> : The MAC Address printed on the
SNT-1010 rear penal is automatically displayed.
No additional setting is required.
<If using an IP sharer>
<IP Address> : Set it according to the private IP
address range provided by the IP Sharer.
ex) 192.168.1.2~255, 192.168.0.2~255,or
192.168.XXX.2~255
<Subnet Mask> : The IP Sharer’s <Subnet
Mask>becomes SNT- 1010’s <Subnet Mask>value.
<Gateway> : The IP Sharer’s <LAN IP
Address>becomes SNT-1010’s <Gateway>value.
<If not using an IP sharer>
For the <IP Address>, <Gateway> and <Subnet Mask>
settings, contact your network administrator.
Before You Start!
Run the <IP Installer.exe> program and display the found SNT-1010 list on the screen.
For the initial run,the [Auto Set] and [Manual Set] button are all disabled.
1
2
3
3