| System Requirements | Installation | | Installation | Installing USB driver | System Requirements z z z OS : Windows XP SP2 USB : Extended Host Controller (EHCT) for USB 2.0 RAM : 256 MB or above | System Requirements Installing USB Installation Install the Application first before connecting the Digital Photo Frame to a PC. 1. Click Frame Manager icon in the main page of the CD manual to run the install file. 2. Press "Next" button. 3.
4. Press "Install" button to proceed. 5. Press "Yes" Button.
6. Select "Yes, I want to restart my computer now" to boot the system. Click on "Finish" button.
When the PC is restarted the Frame Manager icon will appear in system tray. 7. To use the Samsung Digital Photo Frame as USB Secondary Display Go to Control Panel -> Display -> Settings ->Select Samsung Mini-Monitor Display Card. Check Button "Extend my windows desktop on to this monitor" NOTE : Applicable for Windows XP users only. NOTE : Never make this as primary monitor. 8. Press "Ok" or "Apply".
2. Select "No, not this time" button. 3. Click on "Next" button. 4. Click on "Next" button.
5. Select "Install from a list of specific location (Advanced)". Click on Next button. 6. Select "Search for the best driver in these locations" option. Check "Include this location in the search:" Now click on "Browse" button to select the directory where the Frame Manger software is installed. (Refer to Frame Manager Installation step 3). 7. Now press "Next" button.
8. Press "Continue Anyway" button. 9. Press "Finish" button.
10. Now the system is ready to be used.
The Default Mode of the Samsung Digital Photo Frame is a Photo Album. To use the Digital Photo Frame as a secondary USB Monitor or USB Mass-storage device, follow the instructions below. How To Use Digital Photo Frame As Mini-Monitor If USB cable is not connected and Digital Photo Frame is switched on, it starts working as a Photo Album. To use the Samsung Digital Photo Frame device as a secondary USB Monitor, first install the frame Manger on the Windows XP computer.
How To Use Digital Photo Frame As Mass Storage If USB cable is connected to PC, Disconnect and connect again. Following screen will be shown on Digital Photo Frame. Select Mass-Storage option by clicking the button. Use Left / Right (button 5 and button 6 in above figure) button on device for selection and by pressing ENTER button (button 8 in above figure) on device. A dialog box (Window Default) will appear and you can open the folder. How to switch current mode to another 1.
2. From the Menu, Click on menu item Mini-Monitor. 3. Rotate to 90 in Mini-Monitor Mode When the device is in Mini-Monitor mode 0 Degree, select "Rotate to 90°" to rotate the display by 90 degrees. 4. Rotate to 0 in Mini-Monitor Mode When the device is in Mini-Monitor mode 90 Degree, select "Landscape" to rotate the display back to normal 0 degrees position. Brightness Control To control the brightness in MiniMo Mode (i.e.
To Close Frame Manager application Click on Exit menu item. Update Firmware To update the firmware from PC through USB cable, please ensure the following : SAMSUNG Digital Photo Frame must be connected with PC using USB cable Device Mode must be connected as MINIMO or MASS STORAGE Do not disconnect USB cable during UPDATE operation Do not operate or switch of Digital Photo Frame Device during UPDATE operation Remove SD/MMC or CF card, USB stick, if inserted into device before running UPDATE.
9. 10. During the transfer of file/files, following progress bas will appear. After this please wait for completion of update on device.
