Benutzerhandbuch (Windows 7)

20_ Operating the cleaner

Operating the cleaner

INSTALATION ORDER

1. Turning the Power Switch on or off

To use the robotic vacuum cleaner, you must turn on the Power Switch at the

bottom of the main unit.

2. Installing the Charger

To charge the robotic vacuum cleaner, you must ﬁ rst install

the charger.

Since the battery is discharged when the product is

purchased, you must fully charge the battery before use.

3. Charging the Battery

You should charge the battery completely before using the

robotic vacuum cleaner.

4. Setting the Time

You should set the time to use the scheduled and daily

cleaning options.

5. Installing the VIRTUAL GUARD

You can conﬁ ne the robotic vacuum cleaner to a particular section by using Fence

(virtual wall) mode or clean several sections one by one using Guard (virtual door)

mode.

INSTALLING THE ROBOTIC VACUUM CLEANER

TURNING THE POWER SWITCH ON OR OFF

CAUTION

If the Power Switch is turned off, the robotic vacuum cleaner will not be charged

even if it is docked with the charger station.

To use the robotic vacuum cleaner, you must turn the

Power Switch on.

If you turn the Power Switch off, all settings will be reset.

1. Turn over the main unit and turn the Power

Switch on.

- If the icons are not turned on, it indicates that the

battery charge is depleted. In this case, dock the

robotic vacuum cleaner to the charger station after

turning the Power Switch on.

- The conﬁ gured time may be different from the current

time. If the conﬁ gure time is incorrect, set the time to

the current time.

✽ When no key is pressed for approximately 10 minutes

when the power is on, the power is automatically turned

off to save battery power. In this case, to use this robotic

vacuum cleaner again, please push the “Power” button or

“Start/Stop” button.

DJ68-00620Q.indb 20DJ68-00620Q.indb 20 2011.12.10 9:43:56 AM2011.12.10 9:43:56 AM