User Manual (XP)

Operating the cleaner _27
Operating the cleaner
03 OPERATING THE CLEANER
USING THE ROBOTIC VACUUM CLEANER

You can effectively remove dust with the microfiber mop.
1. Attach the mop to the Velcro fastener of the mop
plate.
 
attachment line is not covered.
2. Align the holes of the mop plate with the parts
at the bottom of the cleaning robot and push the
parts until they ‘click’ into place.
 
it may separate while cleaning.
3. Place the mop plate to which the mop is
attached on the floor and push it down.
Parts to install
the mop plate
Mop plate fixing
holes
Mop attachment
line
✽ Attach the mop making sure it is
level with the mop attachment
line.
CAUTION
● Since the cleaning robot cannot move over
carpets after attaching a mop, remove the mop
and mop plate from the cleaning robot before
cleaning a carpet.
● After cleaning, wash the contaminated mop.
● Use the mop only after completely drying it.

● 
not use the mop to clean it to prevent secondary

Mop attachment procedures