User manual

58_ Menu Setup
Menu Setup
• Check Alarm Output Port : If HDD generates check alarm, the alarm signal will output to the specified alarm
output port.
• Replace Alarm Output Port : If HDD generates replace alarm, the alarm signal will output to the specified
alarm output port.
• Duration : Sets the alarm duration for the alarm signal and beep sound.
- Check Alarm, Replace Alarm signals will output through the selected alarm out ports (1, 2, 3, and 4).
` SRN-470D supports only alarms : <1> and <2>.
- If <BEEP> was selected, a beep will sound.
- If <All> was selected, both beep sound and alarm signal through rear side ports will output.
M
` <Check> status means that the HDD is operating but it has problems that require technical examination.
(
) appears on the Live screen.
` <Replace> status means that the HDD has defect and requires immediate replacement.
(
) appears on the Live screen.
Remote Devices
You can specify the ID of a remote control that will operate in sync with NVR.
[MENU]  ▼  <Device>  ►▼  <Remote Devices>  [ENTER]  ▲▼◄►  [ENTER]
• Remote Control : Specify the use of the remote control.
• ID : Select an ID number to synchronize with the remote control.
If it does not match with the remote control ID, the remote control will not operate at all.
M
` For changing the remote control's ID, refer to "Changing the Remote Control ID". (Page 12)