User Manual

2
Use the attached rack mounting template to
locate the holes on the front and rear rack
mounting flanges.
Align the slide rail to the rear mounting
flanges. If the front slide rail bracket does not
align with the front mounting flange, slightly
loosen the rail-length-adjusting screws and
adjust the length of the rail.
Attention: To avoid injury, do not place your
fingers around the rack-support wheels
when positioning the server on the rails.
Ensure that the handles are fully upright
as shown in the illustration above; then, use
the handles to position the server in front of
and level with the rails, aligning the channels
on the sides of the server with the rails. Slide
the server onto the rails, resting the
rack-support wheels on the rails, until the
release latches contact the rails.
Install the slide rails, ensuring that the front
and rear slide rail brackets for both slide rails
are vertically aligned. Insert and partially
tighten the four rear M6 screws ; then,
insert and fully tighten the four front M6
screws .
If you loosened the rail-length-adjusting
screws, tighten them; then, fully extend the
rails out of the rack cabinet until they lock into
place.