User Manual

ManualsBrandsSamsung ManualsDVD VCR ComboSV-DVD40

Your DHR remote control will work with Samsung televisions and

compatible brands.

To determine whether your television is compatible, follow the instructions

below.

1 Switch your television on.

2 Point the remote control towards the television.

Hold down the TV button and enter the two-figure code corresponding

to the brand of your television, by pressing the appropriate

numeric buttons.

Brand Codes Brand Codes

SAMSUNG 01 to 06 PHILIPS 02, 20, 22

AKAI 09, 23 SABA 13, 14, 22 to 24

GRUNDIG 09, 17, 21 SONY 15, 16

LOEWE 02 THOMSON 13, 14, 24

PANASONIC 08, 23 to 27 TOSHIBA 07, 16 to 19, 21

• If your television is compatible with the remote control, it will be

switched off. It is now programmed to operate with the remote control.

➢ ◆

If several codes are indicated for your television brand,

try each one in turn until you find one that works.

◆

When you change the batteries in the remote control,

you must reprogram the code, following the same procedure.

You can control the television using the following buttons.

Button Function

STANDBY/ON Used to switch the television on and off.

INPUT SEL. Used to select an external source.

VOL. + or - Used to adjust the volume of the television.

PROG. Up or Down Used to select the required channel.

TV MUTE Used to toggle the sound on and off.

➢

The various functions will not necessarily work on all

televisions. If you encounter problems, operate the

television directly.

20 21

Using the TV Button on the Remote Control

Connecting DHR(DVD HDD Recorder) to a Satellite Receiver or Other Equipment

You can connect your DHR to a Satellite receiver or other DHR using the SCART cable if the appropriate

outputs are available on the equipment chosen. The following illustrations give a few examples of the

connection possibilities.

1. AV2 IN: By means of 21-pin Scart Cable

Plug the SCART Cable with satellite receiver or other equipment into the AV2 (DEC./EXT.) jack on the rear of the DHR.

After making this connection, select the source by pressing the INPUT SEL. button for the AV2 input sources.

2. By means of RF Coaxial Cable

After making this connection, you must preset the station received through the satellite tuner.

RF output channel of the satellite receiver should be adjusted away from channel 60, which is used by the DHR,

e.g. re-adjust to channel 39.

Satellite Receiver or other Equipment

Aerial

Aerial Connector

SCART Cable

RF coaxial cable