User`s manual

Troubleshooting
96M4011o User’s Manual 5-3
Step5: Please adjust the AT/ATX jumper on JP3 to short 3-5,4-6 pins, then it can
support ATX power scheme.
Step6: Connect TOGGLE SWITCH with J32 connector on 96M4011o.
Step7: The figure below is the TOGGLE SWITCH, which is used to switch the ATX
Power on/off for SBC. Usually the TOGGLE SWITCH is located on the
chassis front panel. Pressing the switch button once will turn power on, and
press again to turn it off.
Q: In addition to the above description, is there anything to do to finish up an
ATX system?
A: Yes. 96M4011o needs to be configured to support ATX function for the
above cabling. Please move jumper JP3 to 3-5 short and 4-6 short (support ATX
function).