Owner's Manual

ENG - 8
࡙ When connecting the speaker cables to the surround speakers, follow these steps:
1. Match the speaker cable connected to the grey jack to the speaker with the grey label.
2. Match the speaker cable connected to the blue jack to the speaker with the blue label.
3. Insert the red and black coloured ends of each speaker cable into the red and black jacks of
the appropriate speaker.
࡙ The labels are on the backs of the speakers.
2. Check the standby status after plugging into an electrical outlet
ťЇ˝ϩ˵ʪǮθʪʪϑϑŵʪʀʪЭʪθđͱʒЇʪΧͱиʪθʀͱθʒϩͱɇʪʪʀϩθʀɇͱЇϩʪϩɇʒϩͱϩ˵ʪǮθʪʪϑϑ
ŵʪʀʪЭʪθđͱʒЇʪϩͱϩЇθͱϩ˵ʪǮθʪʪϑϑŵʪʀʪЭʪθđͱʒЇʪࢋƟ˵ʪøÃĘçøkUʒʀɇϩͱθ࣍ɵЇʪøkU࣎ͱϩ˵ʪ
ǮθʪʪϑϑŵʪʀʪЭʪθđͱʒЇʪɵϑࢋÃ˙ϩ˵ʪøkUʒͱʪϑͱϩɵࡡθʪ˙ʪθϩͱϑϩʪΧߩͱΧɇ˝ʪߢߢࢋ
ID SET
L R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
POWER
STANDBY
LINK
LINK
Blue blinking
Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar
(Applicable only when connecting the SWA-9000S and MS series Soundbars/home
cinemas.)
HDMI IN
HDMI OUT
(TV-ARC)
WIRELESS
AUX IN
DIGITAL AUDIO IN
(OPTICAL)
POWER
IN
POWER
OUT
(For TV)
AC 100V~240V
4A~1.66A
POWER
IN
POWER
OUT
(For TV)
AC 100V~240V
4A~1.66A
Bottom of the Soundbar
Attach the Toroidal ferrite core to the power cord
of the Soundbar to help prevent RF interference
from radio signals.
1. ťЇϩ˵ʪѣу˝ϩɇɵͱ˙ϩ˵ʪƟͱθͱʒɇ˙ʪθθϩʪʀͱθʪϩͱ
open it.
2. Make two loops in the Soundbar’s power cord.
3. Attach the Toroidal ferrite core to the Soundbar’s
Χͱиʪθʀͱθʒɇϑϑ˵ͱиϩ˵ʪѣ˝Їθʪͱϩ˵ʪʪ˙ϩࡡɇʒ
then close it by pressing it until it clicks.
࡙ Ensure that the ferrite core is attached as
close as possible to the power plug of the
Soundbar.