Quick Start Guide

QSG_SWT-F0803MG 08/12/2019 PAGE 10
QUICK START GUIDE
SWT-
F0803MG SERIES
Software Configuration
Attention: While installing and upgrading firmware, please remove physical loop connection first.
DO NOT power off equipment while the firmware is upgrading!
Configuration by Web Browser
About Web-based Management
An embedded HTML web site resides in the flash memory on the CPU board. It contains
advanced management features and allows you to manage the switch from anywhere on the
network through a standard web browser such as Microsoft Internet Explorer.
Preparing for Web Management
The default value is as below:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.254
User Name: admin
Password: *Must be configured prior to login* Refer to p.11
System Login
1. Launch web browser.
2. Type ht tp://192.168.1.1. Press Enter.
3. The login screen appears.
4.
Key in the username and password. The default username is admin. The password must have
been previously configured, otherwise access will be denied. Refer to p.11 to set an inital
password.
5. Select Enter or OK button, then the main interface of the Web-based management appears.
Warning – Any changes made to the settings will apply only to the current running
configuration of the switch and will be lost in the event of a power cycle.
To save any changes made to persistent memory please go to “Maintenance ¦
Configuration ¦ Save startup-config” to write the changes to the switches startup
configuration.