Quick Start Guide

QSG_SWT-F0803MG 08/12/2019 PAGE 16
QUICK START GUIDE
SWT-F0803MG SERIES
Factory Default Procedure
Wisenet switches have a procedure to return the unit to factory default configuration, deleting the
running & startup configuration. This is useful in cases where the configured password cannot be
remembered and the "reload defaults" command can not be used.
1.
Start with switch in the powered-off state. Locate the reset button on the left hand side of the
unit. The reset button is located inside the 3rd hole from the bottom, as shown in the image
below. Press and hold the button using a paper clip.
2.
While holding down the button, power on the unit and wait for 60 seconds. If a console cable is
connected you will see a message showing that a reset has been detected and that the switch
has been reset to factory default.
3.
Once the factory default has been completed and the unit has fully booted, please set a
password using the CLI, as shown on page 11.