Installation Manual

INS_TE(C,U)-FX 08/12/19 PAGE 11
INSTALLATION AND OPERATION MANUAL TE(C,U)-F SERIES
INSTALLATION CONSIDERATIONS
These units are supplied as Standalone/Rack mounted module. Units should be installed in dry locations protected from extremes of temperature and
humidity.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack environment may be greater than
room ambient. Therefore, consideration should be given to installing the equipment in an environment compatible with the maximum ambient temperature (T
ma
)
specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation of the equipment is not compromised.
SBP-C14 / SBP-C03 CARD CAGE RACKS
CAUTION: Although the units are hot-swappable and may be installed without turning power off to the rack, Hanwha recommends
that the power
supply be turned off and that the rack power supply is disconnected from any power source. Note: Remove electrical connector before installing in
card cage rack.
1. Make sure that the
card is oriented right side up, and slide it into the card guides in the rack until the edge connector at the back of the card seats
in the corresponding slot in the rack’s connector panel. Seating may require thumb pressure on the top and bottom of the card’s front panel.
CAUTION: Take care not to press on any of the LEDs.
2.
Tighten the two thumb screws on the card until the front panel of the card is
seated against the front of the rack.
WARNING: Unit is to be used with a Listed Class 2 power supply.