User Manual
Table Of Contents
- overview
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Connecting the Camera Directly to a PPPoE Modem
- Connecting the Camera to a Broadband Router with the PPPoE/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _9
●● INSTALLATION & CONNECTION
installation & connection
INSTALLATION
J
`
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
• It must be installed on the area (ceiling or wall) that can withstand 5 times the weight of the camera
including the installation bracket.
• Stuck-in or peeled-off cables can cause damage to the product or a fire.
• For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
• Do not use the sunshield hole for any purpose other than for connecting the sunshield.
• If you use excessive force when installing the product, the camera may be damaged and malfunction.
If you forcibly install the product using non-compliant tools, the product may be damaged.
Installation
1. Use the four tapping screws provided to secure the base wall
mount.
2. Hang the safety cable up on a hook that looks like an arrow in the
Bottom cover.
3. Connect the appropriate cables with camera terminals.
4. After placing the bottom cover on the base wall mount, use the L
wrench provided to connect and secure the three screws.
5. After placing the camera on the bottom cover, use the L wrench
provided to connect the three screws on the top cover.
6. Adjust the camera direction using the L wrench provided.
J
`
When you adjust the camera position using a bracket, please loosen the bracket
screw, adjust the camera, and tighten it. If you attempt to adjust it forcibly while
the screw is tight, it may result in a scratch or other problems.
Connecting waterproof power cable and LAN cable
1. Pick off the extruded part of the rubber cover on the bottom side of
the bottom cover as shown in the figure below.
J
`
Use an appropriate cable bush for the LAN cable to be connected.
- Basic camera : Use the cable with a diameter of Ø5~6.5.
- Components provided : Use the cable with a diameter of Ø7~8.5.
2. Insert the power cable into the small hole made by removing the
projected part of the rubber plug in step 1 above.
3. Connect the power cable with the power terminal block.
CONDUIT
CAUTION : Be ware o f the
Rated Vo ltage and P olari ty
of the power conne ction .
123 45 67 8
1:LIN E IN
2:GND
3:AUD IO OU T R
4:AUD IO OU T L
5:GND
6:ALA RM IN
7:ALA RM O UT
8:ALA RM OU T2