User Manual
Table Of Contents
- overview
- installation & connection
- network connection and setup
- Connecting the Camera Directly to Local Area Networking
- Connecting the Camera Directly to a DHCP Based DSL/Cable Modem
- Using Device Manager
- Automatically searching camera
- Configuring IP address
- Manually registering camera
- Automatically configuring IP
- Port Range Forward (Port Mapping) Setup
- Connecting to the Camera from a Shared Local PC
- Connecting to the Camera from a Remote PC via the Internet
- web viewer
- appendix
English _11
● INSTALLATION & CONNECTION
INSERTING/REMOVING A MICRO SD CARD
Inserting a Micro SD card
Insert a Micro SD card in the arrow direction shown in the figure.
123 45 678
1:L IN E IN
2:G ND
3:A UD IO OU T R
4:A UD IO OU T L
5:G ND
6:A LA RM IN
7:A LA RM O UT
8:A LA RM OU T2
J
`
Before installing the camera, the Micro SD card should be inserted while the power source and the body are separated.
`
Do not forcefully insert it in the reverse direction. It might damage your Micro SD card and your product.
`
When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
`
Disassembly of the product cover should be finished within 5 minutes, or there will be the risk of internal dew condensation.
Removing a Micro SD card
Gently press down on the exposed end of the memory card as shown in the diagram to eject the memory
card from the slot.
123 45 678
1:L IN E IN
2:G ND
3:A UD IO OU T R
4:A UD IO OU T L
5:G ND
6:A LA RM IN
7:A LA RM O UT
8:A LA RM OU T2
J
`
Before removing the Micro SD card, in <Setup ( )>-<Event>-<Storage>, set the device to <Off> and press the [Apply]
button and turn the camera off.
`
If you turn off the camera or remove the Micro SD card that contains data from the product, the data may be lost or damaged.