Specifications
Table Of Contents
- Chapter 1:Your New TV
- Chapter 2:Installation
- Chapter 3:Operation
- Turning the TV On and Off
- Plug & Play Feature
- Viewing the Menus and On-Screen Displays
- Selecting a Menu Language
- Selecting the Antenna Input
- Memorizing the Channels
- Adding and Erasing Channels
- Changing Channels
- Selecting Your Favorite Channels
- Labeling the Channels
- Picture Control
- Sound Control
- Setting the Clock
- Viewing an External Signal Source
- Chapter 4:Special Features
- Fine Tuning Analog Channels-Analog
- Checking the Digital-Signal Strength-Digital
- Changing the Screen Size
- Tilt
- LNA(Low Noise Amplifier)
- Using the RSurf Feature
- Choosing a Multi-Channel Sound(MTS) track-Digital
- Choosing a Multi-Channel Sound(MTS) track-Analog
- Auto Volume
- Choosing a Digital Sound Format-Digital
- BBE
- Setting the On/Off Timer
- Setting the Sleep Timer
- Using the V-Chip
- How to Change Your Password
- How to Enable/Disable the Rating Controls
- How to Set up Restrictions Using the“TV Parental Guidelines”
- How to Set up Restrictions using the Movie Ratings:G, PG, PG-13, R, NC-17, X
- Important Notes About Parental Locks
- How to Set up Restrictions Using“Canadian English”
- How to Set up Restrictions Using“Canadian French”
- Viewing Closed Captions(On-Screen Text Messages)-Analog
- Viewing Closed Captions(On-Screen Text Messages)-Digital
- Menu Transparency Level
- Setting the Function Help
- Electronic Program Guide-Digital
- Remind List
- Customizing Your Remote Control
- Chapter 5:Troubleshooting
- Appendix
INSTALLATION
English - 14
Chapter Two
INSTALLATION
Connecting VHF and UHF Antennas
If your antenna has a set of leads that
look like this, see “Antennas with
300-ohm Flat Twin Leads” below.
If your antenna has one lead that looks
like this, see “Antennas with 75-ohm
Round Leads” on page 15.
If you have two antennas, see “Separate
VHF and UHF Antennas” on page 15.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from the
twin leads under the
screws on the 300-75 ohm
adaptor (not supplied).
Use a screwdriver to
tighten the screws.
2
Plug the adaptor into the
“ANT 1 IN (Air)” terminal
on the rear panel.
AA68-03739A-01Eng 10/7/05 5:40 PM Page 14