User manual

memo _1514_ Troubleshooting
PROBLEM possible solution
Vacuum cleaner won’t run
• Power cord not plugged in
• Blown fuse/tripped breaker in home
• Check electrical plug
• Check/ Replace fuse or reset breaker
Vacuum cleaner and tools won’t pick up dirt
• Incorrect Height Adjustment
• Hose not attached to suction opening
• Twist Snap Hose not securely attached
• Crack or hole in Hose
• Broken or worn Drive Belt
• Rotating Floor Brush bristles worn
• Rotating Floor Brush jammed
• Clog in vacuum
• Dust Bin full
• Dust Bin not installed properly
• Filters are dirty
• Mini Turbo Brush is clogged or debris is
wrapped around the brush roll
• Adjust Powerfoot to correct height setting
• Firmly push Hose Wand onto the suction
opening
• Make sure Twist Snap Hose is snapped
into locked position.
• Check Hose and replace if needed
• Replace Drive Belt, see pg.12
• Replace Brush
• Remove brush and clean debris from
brush ends
• Clear clog, see pg.10-11
• Empty Dust Bin
• Position correctly and lock in place
• Check Pre-motor and Post-motor lters
• Maintaining Mini Turbo Brush, see pg. 13
Visible dirt escaping from cleaner
• Dust Bin full
• Filters missing or installed incorrectly
• Dust Bin installed incorrectly
• Empty Dust Bin
• Check Pre-motor and Post-motor lters
for correct installation
• Pull out and re-attach Dust Bin correctly
This Vacuum cleaner is approved the following.
Electromagnetic Compatibility Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
Troubleshooting
Check this list of possible problems and solutions before bringing your vacuum to a
service center.