VCMA20CV Vacuum Cleaner user manual ✻ Before operating this unit, please read the instructions carefully. ✻ For indoor use only. English imagine the possibilities Thank you for purchasing a Samsung product. DJ68-00685N.indb 1 2014. 6. 13.
safety information SAFETY INFORMATION WARNING WARNING • Before operating the appliance, please read this manual thoroughly and retain it for your reference. • Because these following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manual. CAUTION/WARNING SYMBOLS USED WARNING CAUTION Indicates that a danger of death or serious injury exists. Indicates that a risk of personal injury or material damage exists.
safety information IMPORTANT SAFEGUARDS 1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner. 2. WARNING: Do not use the vacuum cleaner when rug or floor is wet. Do not use to suck up water. 3. Close supervision is necessary when any appliance is used by or near children. Do not allow the vacuum cleaner to be used as a toy.
safety information 8. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord. 9.
contents ASSEMBLING THE CLEANER 06 OPERATING THE CLEANER 07 MAINTAIN TOOLS AND FILTER 09 07 07 08 ON/OFF Switch Power Cord Power-Control 09 10 11 12 13 14 Using accessory Maintain floor tools Emptying the dust bin When to clean the dust pack Cleaning the dust pack Cleaning the outlet filter TROUBLESHOOTING 15 contents _05 DJ68-00685N.indb 5 2014. 6. 13.
assembling the cleaner • Please do not press the button of dust bin handle when carrying machine. • For storage, park the floor nozzle. 06_ assembling the cleaner DJ68-00685N.indb 6 2014. 6. 13.
operating the cleaner ON/OFF SWITCH CAUTION 02 operating the cleaner 1) BODY CONTROL TYPE 2) ON/OFF TYPE • When removing the plug from the electrical outlet, grasp the plug, not the cord. POWER CORD operating the cleaner _07 DJ68-00685N.indb 7 2014. 6. 13.
POWER-CONTROL BODY-CONTROL TYPE / ON/OFF TYPE • HOSE To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open. • BODY (BODY-CONTROL TYPE ONLY) MIN = For delicate surface e.g. net curtains. MAX = For hard floors and heavily soiled carpets. 08_ operating the cleaner DJ68-00685N.indb 8 2014. 6. 13.
maintain tools and filter USING ACCESSORY • Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth. • To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube. 03 maintain tools and filter Pipe (Option) Accessory • Dusting brush for furniture. shelves, books, etc. • Crevice tool for radiators, crevices, corners, between cushions.
MAINTAIN FLOOR TOOLS 2-Step Brush • Adjust the inlet lever according to the floor surface. Carpet Cleaning • Remove waste matter completely if the inlet is blocked. Floor Cleaning 10_ maintain tools and filter DJ68-00685N.indb 10 2014. 6. 13.
maintain tools and filter EMPTYING THE DUST BIN 03 maintain tools and filter 1. Once dust reaches the 2. Take the dust bin out 3. Separate the dust bin MAX mark, or sution by pressing the button. cover. is noticeably reduced during cleaning, empty the dust bin. click 4. Throw away dust into the bin. - 5. Close the dust bin cover. 6. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the “click” sound.
WHEN TO CLEAN THE DUST PACK - If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. Turn the vacuum power to ‘MAX’. If suction is noticeably reduced with the inlet floating 10cm above flat floor, clean it. When suction is noticeably reduced continuously, please cleaning the Dust Pack as shown in the following illustration. 12_ maintain tools and filter DJ68-00685N.indb 12 2014. 6. 13.
CLEANING THE DUST PACK 1. Remove the dust bin and dust pack as shown. 03 maintain tools and filter 2. Remove the sponge and filter from the dust pack. 3. Wash the sponge and the filter of the dust pack with water. 4. Let the sponge and filter dry in the shade for more than 12 hours. 5. Put the sponge and filter into the dust pack. 6. Put the assembled dust pack into the main body. Make sure the filter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.
maintain tools and filter CLEANING THE OUTLET FILTER Press the fixed frame part at the back of the main body to remove. Remove and replace the blocked outlet filter. Replacement filters are available at your local Samsung distributor. 14_ maintain tools and filter DJ68-00685N.indb 14 2014. 6. 13.
troubleshooting PROBLEM SOLUTION • Check cable, pulg and socket. • Leave to cool. Suction force is gradually decreasing. • Check for blockage and remove. Cord does not rewind fully. • Pull the cord out 2-3m and push down the cord rewind button. Vacuum cleaner dows not pick up dirt. • Check hose and replace if required. Low or decreasing suction • Please check filter and, if required, clean as illustrated in the instructions. if filters are out of condition change them to new ones.
DJ68-00685N.indb 16 2014. 6. 13.
VCMA20CV Aspiradora manual del usuario ✻ Antes de poner en funcionamiento esta unidad, lea atentamente las instrucciones. ✻ Para uso en interiores solamente. Español imagine the possibilities Gracias por adquirir un producto Samsung. DJ68-00685N.indb 1 2014. 6. 13.
información sobre seguridad INFORMACIÓN SOBRE SEGURIDAD ADVERTENCIA ADVERTENCIA • Antes de poner en funcionamiento el aparato, lea detenidamente este manual y consérvelo para su referencia. • Debido a que las siguientes instrucciones de funcionamiento corresponden a diversos modelos, es posible que las características de su aspiradora difieran ligeramente de las que se describen en este manual.
información sobre seguridad PRECAUCIONES IMPORTANTES 1. Lea atentamente todas las instrucciones. Antes de encender el aparato, asegúrese de que el voltaje de la alimentación eléctrica sea el mismo que el indicado en la placa de datos de la parte inferior de la aspiradora. 2. ADVERTENCIA: No use la aspiradora sobre alfombras o suelos húmedos. No la use para absorber agua. 3. Es necesario prestar atención cuando se use la aspiradora cerca de los niños.
información sobre seguridad 8. 9. 10. 11. 12. 13. 14. 15. 16. No bloquee los puertos de succión y de escape. Apague la aspiradora con el botón ubicado en el interruptor de la máquina antes de desenchufarla de la toma de corriente. Desenchufe la aspiradora de la toma de corriente antes de cambiar la bolsa o el contenedor del polvo. Para evitar daños, al desenchufar no tire del cable, sujete el enchufe y tire de él.
contenido ARMADO DE LA ASPIRADORA 06 FUNCIONAMIENTO DE LA ASPIRADORA 07 07 08 Interruptor de encendido/apagado Cable de alimentación Control de encendido HERRAMIENTAS DE MANTENIMIENTO Y FILTRO 09 10 09 11 12 13 14 Uso de los accesorios Herramientas de mantenimiento para piso Vaciado del depósito de polvo Cuándo limpiar la caja para polvo Limpieza de la caja para polvo. Limpieza del filtro de salida 07 SOLUCIÓN DE PROBLEMAS 15 contenido _05 DJ68-00685N.indb 5 2014. 6. 13.
armado de la aspiradora • No presione el botón de la manija del depósito de polvo al trasladar la máquina. • Al guardar la aspiradora, deje la boquilla para pisos como se muestra. 06_ armado de la aspiradora DJ68-00685N.indb 6 2014. 6. 13.
funcionamiento de la aspiradora INTERRUPTOR DE ENCENDIDO/APAGADO 02 PRECAUCIÓN 2) TIPO ENCENDER/APAGAR funcionamiento de la aspiradora 1) TIPO CONTROL EN EL CUERPO • Cuando desenchufe el aparato del tomacorriente, sujete por el enchufe, no por el cable. CABLE DE ALIMENTACIÓN funcionamiento de la aspiradora _07 DJ68-00685N.indb 7 2014. 6. 13.
CONTROL DE ENCENDIDO TIPO CONTROL EN EL CUERPO / ENCENDER/APAGAR • MANGUERA Para reducir la potencia de succión en la limpieza de cortinas, pequeñas alfombras y otros tejidos ligeros, deslice la tapa del aire hasta que se abra el orificio. • CUERPO (SOLO TIPO CONTROL EN EL CUERPO) MIN = Para superficies delicadas, como cortinas de red. MAX = Para suelos duros y alfombras muy sucias. 08_ funcionamiento de la aspiradora DJ68-00685N.indb 8 2014. 6. 13.
herramientas de mantenimiento y filtro USO DE LOS ACCESORIOS 03 Tubo (opcional) Ajuste la longitud del tubo telescópico deslizando el botón del control de longitud ubicado en el centro del tubo telescópico hacia atrás y hacia adelante. • Para verificar que no haya obstrucciones, separe el tubo telescópico y ajústelo de manera tal de acortarlo. Esto facilita la extracción de los desperdicios que obstruyen el tubo.
HERRAMIENTAS DE MANTENIMIENTO PARA PISO Cepillo de 2 posiciones • Ajuste la palanca de entrada según la superficie • Extraiga completamente los del piso. materiales de desperdicio si la entrada está bloqueada. Limpieza de alfombras Limpieza de pisos 10_ herramientas de mantenimiento y filtro DJ68-00685N.indb 10 2014. 6. 13.
herramientas de mantenimiento y filtro VACIADO DEL DEPÓSITO DE POLVO 03 herramientas de mantenimiento y filtro 1. Cuando el polvo llegue hasta la 2. Extraiga el depósito de 3. Separe la tapa del marca MAX o la potencia de succión polvo presionando el depósito de polvo. disminuya considerablemente botón. durante la limpieza, vacíe el depósito de polvo. clic 4. Deseche el polvo del depósito. - 5. Cierre la tapa del depósito de polvo. 6.
CUÁNDO LIMPIAR LA CAJA PARA POLVO - Si la potencia de succión disminuye considerablemente durante la limpieza, verifique la caja para polvo como se indica a continuación. Suba la potencia de la aspiradora a ‘MAX’. Si la potencia de succión disminuye considerablemente cuando la entrada se encuentra a 10 cm por encima del piso plano, límpiela. Si la potencia de succión disminuye considerablemente de forma continua, limpie la caja para polvo como se muestra en la ilustración.
LIMPIEZA DE LA CAJA PARA POLVO. 1. Extraiga el depósito de polvo y la caja para polvo como se muestra. 03 herramientas de mantenimiento y filtro 2. Extraiga la esponja y el filtro de la caja para polvo. 3. Lave la esponja y el filtro de la caja para polvo con agua. 4. Deje secar la esponja y el filtro a la sombra por más de 12 horas. 5. Coloque la esponja y el filtro en la caja para polvo. 6. Vuelva a colocar la caja para polvo armada en el cuerpo principal.
herramientas de mantenimiento y filtro LIMPIEZA DEL FILTRO DE SALIDA  Presione la parte del armazón fijo en la parte posterior del cuerpo principal de la aspiradora para extraer el filtro. Extraiga y reemplace el filtro de salida bloqueado. Los filtros de repuesto están disponibles en su distribuidor local de Samsung. 14_ herramientas de mantenimiento y filtro DJ68-00685N.indb 14 2014. 6. 13.
solución de problemas PROBLEMA SOLUCIÓN • Verifique el cable, el enchufe y el tomacorriente. • Deje enfriar. La potencia de succión disminuye gradualmente. • Verifique si hay obstrucciones y elimínelas. El cable no se enrolla completamente. • Tire del cable unos 2 a 3 m y luego presione el botón para enrollar el cable. La aspiradora no aspira polvo. • Limpie la manguera y reemplácela si es necesario.
Si desea formular alguna pregunta o comentario en relación con los productos de Samsung, comuníquese con el centro de atención al cliente de SAMSUNG País ARGENTINE Centro de atención SAMSUNG 0800-333-3733 Pagína web www.samsung.com/ar/support DJ68-00685N-00 DJ68-00685N.indb 16 2014. 6. 13.