Specifications
OWNER’S GUIDE SOFTWARE | 9203
move it along a waveform. Notice the values shown at the top of the graph:
Using the Cursors
DEWESoft uses these cursors in two ways: to zoom as shown above, and to make measurements on the
signals. To make full use of them, activate the cursor checkbox in the properties panel on the left, when your
recorder graph is active:
Before you check the box Show cursor values, the delta-T is already shown here. In the screen shot above,
notice the label:
dt = 6.7 ms f = 149 Hz
Therefore, the delta time between the cursors is less than 7 ms (<0.007 s), and the reciprocal of that time
interval is 149 Hz.
Now check the Show cursor values box, and notice that the recorder graph will get a new panel on its right
side, which shows the cursor I and cursor II values in a table:
So we see the value of the channel called Master Cylinder at cursor I, cursor II, and then the calculated delta
amplitude value.