Specifications
9-220 | OWNER’S GUIDE
Data header
In this subsection of the Project setup, you can dene a form that will appear when you record data, in order
to collect some additional information from the operator about the test.
When you rst come to this subsection, it will look like the screen shot above. The main part of the dialog
box will be completely empty, as shown here. This is your workspace, where you can create data input elds
that the test operator will use later. There are three things that you can add to this workspace:
Info - This is basically just a section header, which you can freely name.
Input - A eld which will collect alphanumeric input from the user
Selection - A control that allows the user to pick from a list that you have predened
OK, let’s see how all these work. It is normally a good idea to start by writing down on paper what you want
to collect from the user. Just use a piece of paper, and then refer to it as you duplicate it in the software.
Let’s say that you want to collect this information, arranged in these groups:
Test operator info:
name
ID number
Test article info:
model name (could be model A, model B, or model C)
serial number
lot number
Test procedure info:
ATP number (could be 1-1, 1-2, 1-3, or 22a)
ATP step (could be any number from 1 to 100)