Specifications

13-326 | OWNER’S GUIDE
Parameter DAQP-STG
Typical SNR @ 100 kHz [1 kHz]
and 5 VDC excitation:
66 dB [84 dB] @ 1 mV/V
82 dB [100 dB] @ 50 mV/V
Typical CMRR @ 0.1 mV/V [1 mV/V]
and 5 VDC excitation:
160 dB [160 dB] @ DC
115 dB [110 dB] @ 400 Hz
110 dB [105 dB] @ 1 kHz
Isolation ±350 VDC continuous (for input, excitation and TEDS interface)
Common mode Voltage ±350 VDC input to housing
Over voltage protection: ±50 VDC input (+) to input (-)
Output voltage: ±5 V
Output resistance: < 1 Ω
Output current: Max. 5 mA; short to ground protected for 10 seconds
RS-485 interface: Yes
TEDS support: Yes, compatible with TEDS chips DS2406, DS2430A, DS2431, DS2432, DS2433
MSI support: MSI-BR-TH-x, MSI-BR-ACC, MSI-BR-V-200 ,MSI-BR-CH-50
Power supply voltage: ±9 VDC (±1 %)
Power consumption:
Typ. 1.7 W @ 350 Ω, 2.15 W @ 120 Ω (both full bridge @ 5 VDC excitation)
Absolute max.: 3 W (maximum excitation @ maximum current)
Module Pin-outs
⇒ CAUTION: The sensor shield can be connected to either pin 4 (SUB-D version only) or the housing of the 9-pin
SUB-D / 8-pin LEMO connector, depending on your application.