Specifications

13-344 | OWNER’S GUIDE
Full bridge signal connection
4-wire sensor for standard bridge & inductive bridge (Sense wired at the connector)
- Sense leads (SUB-D: pin 3 and 6) could be connected to be compatible to other modules.
Half bridge signal connection
3-wire sensor for standard bridge (Sense wired at the sensor)
Quarter bridge signal connection
3-wire sensor for standard bridge (Sense wired at the connector)
- Sense leads (SUB-D: pin 3 and 6) could be connected to be compatible to other DEWE-BRIDGE amplifier.
- 1) ‘R+’ has to be connected only if shunt calibration is required, otherwise it can be left unconnected.