Specifications
OWNER’S GUIDE CONDITIONERS, PAD | 14363
14
PAD series Signal Conditioners
PAD Series Common Information
Calibration information
All DEWETRON modules are calibrated at 25°C after a warmup time of 30 minutes and meet their speci-
cations when leaving the factory. The time interval for recalibration depends on environmental conditions.
Typically, the calibration should be checked once a year.
Calibration certicates are available from DEWETRON as an option. DEWETRON offers several types:
NIST traceable DEWETRON calibration certicate (USA CAL LAB only)
ISO traceable DEWETRON certicate (European CAL LAB only)
Calibration certicate according to ÖKD (equivalent to DKD)
This manual contains no calibration information. There is a separate calibration kit available for DAQ series
modules manual calibration. The CAL-KIT contains the required cables, software and instructions that you
need to add to your own calibration lab. It does not include a calibrator or volt meter.
General PAD module specications
Module dimensions: 20 x 65 x 105 mm (0.79 x 2.56 x 4.13 in.)
(W x H x D without front cover and connectors)
Frontcover: 20 x 87 x 2 mm (0.79 x 3.43 x 0.08 in.)
(W x H x D without connector)
Environmental:
Temp. range storage: -30 °C to +85 °C (-22 °F to 185 °F)
Temp. range operating: -5 °C to +60 °C (23 °F to 140 °F)
Rel. humidity (MIL202): 0 to 95 % at 60 °C, non-condensing
RFI susceptibility: ±0.5 % span error at 400 MHz, 5 W, 3 m
All specications within this manual are valid at 25 °C.
All modules are produced according to ISO9001 and ISO14001.