Specifications

OWNER’S GUIDE  CONDITIONERS, PAD | 14377
PAD-AO1 Isolated 1-channel Analog Output module
Module purpose: Driving a DC analog output
Isolation: 300 VDC
Signal connection: 25-pin D connector
Important note: This module is not supported by DEWESoft
data acquisition software
PAD-AO1 specications
Parameter PAD-AO1
Output channel: 1 analog VDC output channel
Output signals:
Voltage
Current
0 to 10 V
0 to 20 mA or 4 to 20 mA
Resolution: 12-bits
Accuracy: ±0.1 % of FSR
Read-back accuracy: ±1 % of FSR
Rad-back resolution: ±0.02 % of FSR
Zero drift:
Voltage output
Current output
±30 μV/°C
±0.2 μA/°C
Span temp. coefficient: ±25 ppm/°C
Programmable output slope: 0.125 to 1024 mA/sec or 0.0625 to 512 V/sec
Current load resistor: 500 Ω
Isolation: 300 VDC
RS485 interface for module control/data: Ye s
Power supply voltage: +12 VDC (±10%)
Power consumption: 1.2 W typical
OUT