Specifications
OWNER’S GUIDE D310 | 345
Installing the Smart Batteries (310-UPS option)
Systems are shipped with the hot-swappable bat-
teries removed. You should install them, connect
power, and charge up the batteries. Please follow
these guidelines shown in the previous section,
Accessing the Batteries.
⇒ Never use any battery which appears to be dam-
aged, or which is cracked, broken, hot to the touch,
or unusual in any way. Lithium batteries can be
dangerous if mistreated or improperly charged.
Please locate your DPS-2410 external power sup-
ply. This is included with the battery option.
♦ Connect the included AC power cord to the DPS-
2410, and then to a 120VAC power receptable.
♦ Connect the included DC power cord to the DPS-
2410 and then to the D310’s DC power input
jack.
♦ Turn on the DPS-2410 power switch. A power
LED will conrm that that it is receiving AC power
and operating properly.
⇒ Do not block the cooling fan of the DPS-2410! Over-
heating any electrical component is dangerous.
For faster recharging, do NOT power up the D310
mainframe, but make certain that the DPS-2410 is
powered on and all power connections are made as
shown below.
Using the smart batteries
The SideHAND2 “smart batteries” supplied with your
Dewetron battery powered system are equipped with
an integrated circuit which stores information such
as manufacturer, serial number, production date,
etc., and monitors the current battery status in terms
of discharge rate, predicted remaining capacity,
temperature, voltage etc.
SideHAND2 “smart batteries” are capable of display-
ing their charge state even when not plugged into
anything.
1) Connect the AC
power plug to a valid
AC mains source
2) Connect the other
end of the AC cord to
the DPS-2410
3) Connect the DC power
cord between the DC output
of the DPS-2410 and the
input of the 301-UPS option
4) Connect the short DC
cable between the 310-UPS
output and the D310 DC
power input.