Specifications
OWNER’S GUIDE DEWE3210 | 595
Operation Guidelines
System Startup Protocol
Installing the Smart Batteries
Systems are shipped with the hot-swappable bat-
teries removed. You should install them, connect
power, and charge up the batteries. Please follow
these guidelines:
♦ Open the battery door on side of DEWE-321x
and insert one battery into the top slot, and the
other into the bottom slot. Leave the center slot
open unless you have a third battery!
♦ When inserting the rst battery you may notice
that the system LEDs and fans will turn on for a
second, this is normal when the battery module
“wakes up.”
⇒ Never use any battery which appears to be dam-
aged, or which is cracked, broken, hot to the touch,
or unusual in any way. Lithium batteries can be
dangerous if mistreated or improperly charged.
Please locate the BATTERY STATUS LCD, located on
the panel just above the keyboard.
♦ With batteries in place, the LCD screen will
display the charge level, charge/discharge state,
power consumption and total current.
♦ The LCD (and battery module circuit) will always
be ON, unless the batteries are removed
Please locate your DPS-2410 external power sup-
ply. This is included with each DEWE-321x system.
♦ Connect the included AC power cord to the DPS-
2410, and then to a 120VAC power receptable.
♦ Connect the included DC power cord to the DPS-
2410 and then to the DEWE-3031’s DC power
input jack.
♦ Turn on the DPS-2410 power switch. A power
LED will conrm that that it is receiving AC power
and operating properly.
The battery door on the side of the DEWE-321x is hinged,
allowing you to access the battery compartment. Batteries can
be removed by pulling on their flexible tabs.
The DPS-2410 AC/DC converter/power supply is fused with
an automotive type power fuse. Please replace only with the
same type and rating of fuse.
The battery status LCD keeps you informed of how many
batteries are installed (2 above), the charge level (100%
above), and whether the system is charging or discharging.