User Manual

ENGLISH-13
When the battery indicator blinks
during cleaning, the POWERbot
will return to the docking station to
charge itself automatically.
Automatic charging
You can command the POWERbot
to recharge at the docking station
while it is in cleaning.
Recharging
Manually charge the POWERbot by
placing it on the docking station.
Low battery (Lo)
Steps to take if recharging not occuring:
Check the installation status of the
docking station when:
fthedockingstationislocatedinaplacewherethe
POWERbotcannoteasilyaccessit.
fthedistancebetweenthedockingstationand
POWERbotisover20ft(5m)
- ItmaytakealongtimeforPOWERbottoreturnto
thedockingstationforrecharging
Manually charge the POWERbot when:
fthedockingstationislocatedinacorner
fthebatteryisfullyexhausted
fthePOWERbotisimmobilizedbyanobstacle
(furnitureetc.)
fthePOWERbotcan'tclimbathresholdnearthe
dockingstation(Themaximumheightofathreshold
thePOWERbotcanclimbisabout0.8in(2.0cm)).
fwhenthebatteryindicatorblinksand"Lo"is
displayed
fwhenthePOWERbotissettotheSpotcleanor
Manualcleanmode
SR9300K_3ge_DJ68-00743A-08_AA.indb 13 2018-11-09 오후 3:22:33