User Manual

ENGLISH-32
Troubleshooting
Symptom Checklist
The POWERbot is not
working at all.
fCheckiftheemergencyswitchison.
fCheckifalltheiconsaredisplayedonthedisplaypanel.
fCheckifthePOWERbot'sbatteryisdepleted.
- When"Lo"isdisplayed,carryPOWERbottothedockingstationto
chargeit.
fReplacethebatteries(AAAtype)iftheremotecontrolisnotworking.
The POWERbot has stopped
during cleaning.
fWhen"Lo"isdisplayedonthedisplaypanel,carryPOWERbottothe
dockingstationtochargeit.
fWhenPOWERbotisimmobilizedbyanobstaclesuchasacord,
thresholdetc,pickitupandmoveitawayfromtheobstacle.
- Ifanyfabricorstringiscaughtinadrivewheel,turnofftheemergency
switchandremovethefabricorstringbeforeusingitagain.
Suction power is weak.
fIfthe"Filterinspectionindicator"ison,turnofftheemergencyswitchand
cleanthedustbin.
fWhenthere'stoomuchdustinthedustbin,suctionpowermayget
weakened.Turnofftheemergencyswitchandemptythedustbin.
fIftheintake(onbottomofPOWERbot)isblockedbyforeignmatter,turn
offtheemergencyswitchandremoveforeignmatterfromtheintake.
fWhennoisesuddenlyincrease,turnofftheemergencyswitchandempty
thedustbin.
The POWERbot cannot find
the docking station.
fCheckifthere'sapowerfailureorwhetherthepowerplugisunplugged.
fRemoveanyobstaclesaroundthedockingstationthatmayprevent
POWERbotfromreturningtothedockingstation.
fWhenthere'sforeignmatteronthechargepins,chargingcanbe
affected.Cleantheforeignmatteroffthepins.
The POWERbot suddenly
cleans diagonally.
fCheckifthedockingstationisinstalledalongthegrainofwoodenfloors
ortiles.
fThePOWERbotmaycleaninadiagonaldirectionifitismovingto
anotherareausingtheshortestroute.Itmayalsomoveatadiagonal
ifitmadecontactwithanobstaclesatthatangle,ifitwaschargedat
thedockingstationatanangle,orifthegrainofthewooden/tilefloor
skewedisinthatdirection.
Point cleaning is not
working.
fIfyoupointtheredlightdirectlyatPOWERbot,itmaynotmovein
desireddirection.
- Pointtheredlightonthefloorwithin4ft(1m)ofPOWERbot.
 Donotusepointcleaningindirectsunlight,underbrightlight,orondark
floors.
"Filter inspection indicator"
is on even after the dustbin
has been emptied.
fTurnofftheemergencyswitchandthenturnitbackon.
fEmptythedustbinagainandre-cleanthefilterthoroughly.
SR9300K_3ge_DJ68-00743A-08_AA.indb 32 2018-11-09 오후 3:23:03