User Manual

1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise
until it locks in position.
HOW TO CLEAN THE FILTER
8
CLEANING THE FILTER NET
HOW TO ADD THE FABRIC SOFTENER
● When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
● Do not use detergent, bleach or starch into the Softener Inlet.
● Using too much softener may produce unsatisfactory results.
● Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness
will decrease.
● Do not leave the softener into the
Softener Dispenser for a long time.
Because softner became stiff.
IN CASE OF COLD-HOT WATER WASHER
● If you use only cold water inlet hose,
you must fit the cap to the hot water
inlet valve as following.
Pour it slowly
1.Push the upper part of
the filter and pull in.
2.Open the cover as
shown in the figure.
3.Clean the filter. 4. Close the cover and insert the lower
part of the filter in the basket first and
then push the filter with "click" sound .
Cold
Hot
cap
1.Open the detergent box by pulling in the
direction of the arrow as shown in the
figure and then put the powder detergent
in the detergent box.
2.Put in one-time amount
of detergent evenly
so the detergent may
not brim over the box.
HOW TO PUT THE DETERGENT IN
1. Check the 4 Legs.(Front-right, Front-left, Rear-right, Rear-left)
2. Lay down the Washing Machine to the front.
3. Insert the hook of leg into the square hole of base.
4. Push the leg to the arrow direction to “click”.
5. Finally fix the legs on the base with screw like a figure.
HOW TO ASSEMBLE THE LEGS
1
2
Leg
Hook
Base
Square Hole
Screw