User Manual(Web)

Connecting the Cover-Stand (WAM750, WAM751 Only)

1 Before attaching the Cover-Stand, remove the

rear cover.

Insert the power cable through the Cover-Stand

hole into the M7 power port.

2 The inside of the Cover-Stand has two sides.

One side (A) has four tabs - two large tabs and

two small tabs. The other side (B) has two large

tabs only. Insert the two large tabs on side A into

the two slots in the area marked A in the diagram.

3 Turn the M7 so the side marked B in the diagram

is facing you. With the thumbs of both hands,

press side B of the Cover-Stand so that the tabs

on side B snap into the slots in the area marked B

in the diagram. You may need to press side B of

the Cover-Stand with some force.

4 The M7 can now be installed vertically.

Caution

Do not place the M7 on an unstable surface.

NOTES

Turn the speaker upright using the stand to set the

speaker to MONO mode.

Turning the product upright or laying it down in the

middle of playing music may temporarily cause unstable

sound.

VOLUME

➡