User manual

SAMSUNG Computer WF10

■

Using the front digital sound output jack(S/PDIF-Optical)

1. Double-click on the ESS Canyon3D 2 Audio Properties ( ) icon on the Taskbar.

2. Select the S/PDIF tab and make check the Enable S/PDIF Out item.

When using the 5.1 channel speakers, use the volume control on the speakers

to adjust the volume.

■

Setting up the rear digital sound output jack

(S/PDIF-Coaxial)/Analog(5.1 Speakers)

The digital output jack on the rear soundcard (S/PDIF-Coaxial)/Analog

(Center/Sub Woofer Speaker) may be setup to output digital or analog sounds.

The default setting is setup on digital sound (4 Speaker).

Follow the instructions below to change to analog setting.

1. Double-click on the ESS Canyon3D 2 Audio Properties ( ) on the

Taskbar.

2. Select the Speaker Setup tab, Select 5.1 Speakers to setup for analog sound.

The Enable S/PDIF Out on the

S/PDIF tab must be enabled to out

put digital sound.

When using digital S/PDIF speakers,

you may use the S/PDIF-Optical port

in the front or S/PDIF-Coaxial in the

rear as they both serve the same

purpose.

Computer WF10-2 3/7/02 5:04 PM Page 14