User manual

Adding additional Hard Drive
This computer comes with 1 Hard Drive. You may add 1 additional Hard Drive to
your computer.
1. Open the Computer Cover.
(Refer to instructions on disassembling computer)
2. Install the Additional Hard Drive bracket on the right side of the exiting
Hard Drive using 2 screws.
3. Assign the new Hard Drive jumper to Slave.
(Please refer to the Hard Drive user’s manual or instructional label)
4. Unplug the Signal and Power Cables from the existing Hard Drive, and
arrange the signal cables to be shown the slave connector.
5. After connecting the Signal Ribbon Cable (the Master end) and Power
cable to the existing Hard Drive, connecting the Signal Ribbon Cable
(the Slave end) and Power Cable on the new Hard Drive.
Slave connector
63
Chapter 4. Upgrading your computer
computer WF10-4 3/7/02 5:12 PM Page 11