User manual

SAMSUNG Computer WF10

■

Example of a drive sequence setup

Sequence 1 2 3

Cable type Primary Hard Drive cable Secondary Hard Drive cable

Jumper setup Master Slave Master

Current status Hard Drive CD Drive

Drive text (C:\ ) (D:\ )

With 1 additional Drive Hard Drive Added Hard Drive CD Drive

text Hard Drive (C:\ ) (E:\ ) (D:\ )

Hard Drive over 60GB may be divided into 2 different partition drives

(C:\ and D:\). In such as the case, the next drive text will fall into the next

alphabet sequence (e.g. E, F).

■

Signal cable guide

You may be equipped with an 80PIN or 40PIN signal ribbon cable.

The 80PIN cable is a yellow cable that is used as the Primary Hard Drive cable

and has preassigned Master and Slave positions.

The 40PIN cable assigns drive sequence according to the drive’s jumper rather

than the cable itself (cable select).

Example) 80PIN cable

SYSTEM (Blue)

Connects to the Primary Hard Drive

connector on the Motherboard

SLAVE (Grey)

Connects to the

Slave drive

MASTER (Black)

Connects to the

Master drive

SAMSUNG Computer WF10

computer WF10-4 3/7/02 5:12 PM Page 16