User manual

SAMSUNG Computer WF10

Q&A

The following is frequently asked questions regarding the use of your computer,

and their answers.

When turning your computer ON

Q I’m getting the ‘Invalid system disk, Replace the disk, and then press

any key’ message.

A You have a general diskette in the floppy drive. Take the general diskette

out or replace with a booting diskette and press any key on the keyboard to

resume.

Q I’m getting the ‘Operating system not found’ message.

This message appears when there is an error in the Hard Drive connection

or BIOS Setup Utility. Please check these items.

A1 Check if the Hard Drive signal cable and power cable are connected

properly.

A2 Check if the BIOS Setup Utility recognizes the Hard Drive properly.

The primary menu’s primary IDE master category is setup for automatic

recognition.

Drive instruction booklet and setup the primary IDE master category.

A3 Check if the Hard Drive jumper setup is correct.

(Refer to Chapter 4 Setting up your drive sequence)

A4 The Hard Drive operating system is damaged. Please reinstall Windows.

Q I’m getting the ‘Press <F1> to continue and <F2> to return to install’

message.

A4 The BIOS Setup Utility setup and system environment are not compatible.

Reset to meet system environment.

1. Refer to Chapter 4 to run BIOS Setup Utility.

2. Press <F9> to enter Setup Confirmation.

Select <Yes> and press <Enter>.

If devices have been added, reset items relative to that driver.

3. Press <F10> to enter Setup Confirmation.

Select <Yes> and press <Enter> to restart.

computer WF10-5 3/7/02 5:18 PM Page 8