User manual

SAMSUNG Computer WF10
82
SAMSUNG Computer WF10
Power save mode
Q Can I connect an USB device while in the power save mode.
A When you connect an USB device in the power save mode, you may not
receive a normal display. An USB device must be connected while you are
in standard operation mode.
Q My USB device won’t operate properly after leaving the power save
mode
A Unplug and then plug in the USB device again.
Q My display is not normal after entering power save mode while in the
DOS window.
A Press on the <Alt> and <Tab> keys simultaneously.
Q I can’t run the ACPI (power management control) power save mode
after adding an expansion card or driver
A Check whether the added card or driver support the ACPI function.
If the function is not supported, run start > Control Panel > Performance and
Maintenance > Power Options, and set the system standby mode on
‘Never’ in Power Schemes.
Q I cannot run the ACPI (power management control) power save mode
while using application programs or games
A Check whether the application or game support the ACPI function.
If the function is not supported, run start > Control Panel > Performance
and Maintenance > Power Options, and set the system standby mode on
‘Never’ in Power Schemes.
Communication
Q I use an inter-office telephone, but I can’t get a dial-tone.
A If you are on a private switchboard (including key phone) system that
requires dialing “9” to get an outside connection, you must setup the
following command before use.
(Or add in the modem initialization command)
-Setup the ATX3 command before use.
-Additionally, if you need to dial “9” before making calls, you insert “9” after
the ATDT. (e.g.: ATDT9,3679-1433)
computer WF10-5 3/7/02 5:18 PM Page 12