User Manual

Installation
Installation
English24
To connect the water hoses to the faucets:
1. Connect one end of each water hose to
the Hot or Cold tap.
2. Turn the ttings by hand until they are
tight, and then tighten them by just an
additional two-thirds of a turn with a
pliers. Do not overtighten the ttings.
You can damage them.
3. When done, pull the water hoses up
and down to check if they are properly
connected.
4. Put the other ends of the hoses into
a bucket and open the taps for 10-15
seconds to remove impurities. When
done, close the taps.
WF5500M_DC68-03773A-05_EN.indd 24 3/15/2019 4:54:42 PM