User Manual
Table Of Contents
- DC68-04006Y-04_IB_WF8500A_EN_230628
- DC68-04006Y-04_IB_WF8500A_CFR_230628
- Consignes de sécurité
- Remarques importantes sur les consignes de sécurité
- Symboles de sécurité importants
- Consignes de sécurité importantes
- AVERTISSEMENT CONCERNANT LA PROPOSITION 65 DE L'ÉTAT DE CALIFORNIE
- Avertissements importants concernant l'installation
- Mises en garde pour l'installation
- Avertissements importants concernant l'utilisation
- Mises en garde concernant l'utilisation
- Avertissements importants concernant le nettoyage
- Notification de réglementation
- Installation
- Avant de démarrer
- Opérations
- Maintenance
- Dépannage
- Caractéristiques techniques
- Consignes de sécurité
- DC68-04006Y-04_IB_WF8500A_MES_230628
- Información sobre seguridad
- Lo que necesita saber sobre las instrucciones de seguridad
- Símbolos de seguridad importantes
- Precauciones de seguridad importantes
- PROPOSICIÓN 65 DE CALIFORNIA: ADVERTENCIA
- Advertencias fundamentales para la instalación
- Precauciones para la instalación
- Advertencias fundamentales para el uso
- Precauciones de uso
- Advertencias fundamentales para la limpieza
- Aviso regulatorio
- Instalación
- Antes de comenzar
- Funcionamiento
- Mantenimiento
- Solución de problemas
- Especificaciones
- Información sobre seguridad
English
English 55
Information codes
If the washer fails to operate, you may see an information code on the screen. Check the table below and
try the suggestions.
Code Action
1C
Check the water level sensor.
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
• Depending on the model, the drain system may drain water automatically. The
Power and Start/Pause (Hold to Start) buttons may be disabled during this
process.
DC
The door is open.
• Close the door and press Start/Pause (Hold to Start) to resume operation.
DC1
Check the door switch.
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
LC
Check for water leaks.
• Power the washer off, and then check the drain system for any leaks. Once the
leak issue is resolved, power the washer on.
• Depending on the model, the drain system may drain water automatically. The
Power and Start/Pause (Hold to Start) buttons may be disabled during this
process.
4C
Check the water supply line.
• Check the connection to the water lines (including water taps).
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
• Depending on the model, the drain system may drain water automatically. The
Power and Start/Pause (Hold to Start) buttons may be disabled during this
process.
4C2
Laundry needs protection because the water being supplied is too hot.
• Make sure the cold and hot water taps are properly connected.
• Power the washer off. Wait 2-3 minutes, power the washer on, and then try
again.
5C
Check the drain system.
• Make sure the drain filter is not clogged.
• If the drain filter is clogged, clean the filter, and then restart the washer.
HC
Check the washing heater.
• Power off the washer, and then contact a Samsung service center.
Untitled-16 55 2023-06-27 5:23:36